Or, you can wire it up on a breadboard. Heads up! The datasheet states: "The sensor cannot be addressed by I2C protocol; however, the sensor can be connected to an I2C bus without interference with other devices connected to the bus. The controller must switch between the protocols. Make sure you test extensively if adding this to an I2C bus containing other sensors.
|Published (Last):||9 October 2008|
|PDF File Size:||1.45 Mb|
|ePub File Size:||1.98 Mb|
|Price:||Free* [*Free Regsitration Required]|
The SHTxx is a single chip relative humidity and temperature multi sensor module comprising a calibrated digital output. The device includes a capacitive polymer sensing element for relative humidity and a bandgap temperature sensor. Both are seamlessly coupled to a 14bit analog to digital converter and a serial interface circuit on the same chip. This results in superior signal quality, a fast response time and insensitivity to external disturbances EMC at a very competitive price.
Each SHTxx is individually calibrated in a precision humidity chamber with a chilled mirror hygrometer as reference. The calibration coefficients are programmed into the OTP memory.
These coefficients are used internally during measurements to calibrate the signals from the sensors. The 2-wire serial interface and internal voltage regulation allows easy and fast system integration. Its tiny size and low power consumption makes it the ultimate choice for even the most demanding applications. The device is supplied in either a surface-mountable LCC Leadless Chip Carrier or as a pluggable 4-pin single-in-line type package.
Customer specific packaging options may be available on request.
SHT15 Humidity and Temperature Sensor Hookup Guide